Call us now ! Send us an email http://maps.google.com/maps?q=1605 E Robin Ln Muncie United States

Back to Top

Call Us Today!
(765) 289-6972
Call Us Today!
(765) 289-6972

How to Change Whole House Filter

Whole house filtration is designed to protect your investment and aid in the performance of your water softener.  It is installed before your unit to stop sediment from entering your softener and save you from costly repairs.  Sediment that enters your softener can cause service problems by plugging ports, stopping gear movement, scoring or marring of internal parts, and clogging of media beds.  Preventative maintenance on your pre-filter will save you time, money, and headaches if done on a regular basis.
We recommend Source changing your pre-filter every 1 - 2 months.
There are different types of pre-filters based on the age of your unit and/or application of equipment.  To change any pre-filter you would follow the same basic steps.
Step 1:  Fill a bucket with soft water.
Step 2:  Turn water off at the inlet side of pre-filter and open a faucet on the outlet side near your water softener.
Step 3:  Relieve pressure from the pre-filter via the red pressure release button or valve.
Step 4:  Unscrew housing
*Note:  It is common to lose the o-ring from housing during pre-filter changes, located on the inner lip of canister.  Be sure to locate the o-ring.
Step 5:    Remove filter.
Step 6:    Clean inside of filter housing with small amount of household bleach or any rust-out solution (CLR, The Works, etc.).  Rinse clean (use the bucket of water).
Step 7:    Replace filter.
Step 8:    Screw housing back onto cap 
 *Note:  Be sure o-ring is in place and clean of all debris. You may want to lube the o-ring with silicone grease (not vasoline) every 6 months.
Step 9:    Do not over tighten.  Hand tightening is sufficient.
Step 10:  Turn water on, check for leaks.
Step 11:  Repeat steps 6-9 if leak occurs and double check o-ring is clean and unobstructed.